Honda Civic (1992-1995) - Change Trunk Brake Light
 | |
| Manufacturer | Honda |
|---|---|
| Production | 1992-1995 |
| Assembly | Suzuka, Japan East Liberty, Ohio Alliston, Ontario, Canada, Lahore, Pakistan, Hsinchu, Taiwan, Thailand, South Africa Nelson, New Zealand |
| Predecessor | Honda Civic (fourth generation) |
| Successor | Honda Civic (sixth generation) |
| Class | Subcompact |
| Body style(s) | 2-door convertible/Targa top/coupe (EJ1/2) 3-door hatchback (EH2/3) 4-door sedan (car) (EG8/EG9) |
| Layout | Front-engine, front-wheel drive layout Front-engine, four-wheel drive layout |
| Engine(s) | 1.3 L Honda D engine #D13 Straight I4 1.5 L Honda D engine #D15B7 Straight I4 |
| Transmission(s) | 4-speed Automatic transmission 5-speed Manual transmission |
| Wheelbase | 101.3 in (257 cm) (hatchback) 103.2 in (262 cm) (coupe & sedan) |
| Length | 160.2 in (407 cm) (hatchback) 172.8 in (439 cm) (coupe) 173.0 in (439 cm) (sedan) |
| Width | 66.9 in (170 cm) |
| Height | 50.7 in (129 cm) (Hatchback) 50.9 in (129 cm) (Coupe) 51.7 in (131 cm) (Sedan) |
| Curb weight | Sedan '92-'93 DX M/T 2,275 lb
|
| Fuel capacity | All USDM Coupes, Hatchbacks and Sedans except the CX & VX {11.9 US gal CX & VX Hatchbacks 10 US gal |
| Related | Honda CRX Honda Ballade Honda CRX Del Sol Honda Concerto Honda Domani Honda Integra |
Contents |
[edit] Tools Needed
- Phillips screwdriver
[edit] Supplies Needed
- New light bulb
[edit] Instructions
- Open the trunk
- Disconnect the electrical wires from the hold-down clip by sliding them out toward the center of the vehicle.
- Detach the two screws from the bulb holder using a Phillips screwdriver.
- Remove the bulb holder from the brake light assembly.
- Verify which bulb needs to be replaced by having someone press the brake pedal while you look at the lights.
- Push the bulb gently into the housing and turn it counterclockwise until it comes loose.
- Insert the new bulb into the socket by pressing it in slightly and turning it clockwise until it locks into place.
- Test the new bulb before moving to the next step.
- Reinstall the bulb holder assembly and reattach it with the two screws.
- Tighten the screws using a Phillips screwdriver.
- Place the wires back in their original location in the hold-down clip.
- Close the trunk.
